Hello. 2014 RAM PROMASTER 2500 150k miles. Most of the time I find my answers by just searching here. This time I'm not totally clear. I checked the level of transmission fluid with the zip tie that was mentioned in another post on here. It worked good. I feel like it's higher than some others mentioned. I can't really find the actual specs on how many millimeters it should be. I have at least 70-80mm at around 70 degrees. Does anyone know what it should be? My plan is to drain and replace the filter this week. I have a P0869 (trans pressure low) and P0740 (torque converter circuit/clutch open) . I figured it's worth a try to do the drain/fill and filter since it's never been done. Not sure that will fix it but it's worth a try maybe. Van runs fine, just feel a couple odd shifts occasionally. Thanks
Michael Schultz
Michael Schultz, you messy kid! Seriously though, I can't see how dropping that pan could ever not be a messy job. I am curious if you put the pan back on with RTV or used the Fel Pro gasket option.
The factory RTV on my tranny pan started leaking and I pulled the pan and replaced it with a gasket. I was as meticulous as you were with the torque sequence. 10k miles later and all is well.👍🏻
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
