Ram Promaster Forum banner

1 - 6 of 6 Posts

Registered
Joined
2,726 Posts
Discussion Starter #1 (Edited)

Registered
Joined
824 Posts
CW Laurence

If anyone is looking for one, these are on sale,

https://www.vanwindowsdirect.com/collections/ram-promaster-van-windows/products/willglass-passenger-sliding-door-solid-glass-window-ram-promaster-van-14-19

Actually a lot of windows are on sale for the PM

They are using the highest MSRP and slashing the price to make it seem like a deal, but the price is the same on other sites.

I dont know about these ones, but I bought & Installed a CW Laurence in my passenger slider & could not be happier. If I did itnagain I would go with CW Laurence again
 

Registered
Joined
32 Posts
I have been looking at these for a year now and the 鈥渟ale鈥 price hasn鈥檛 changed.

But - they carry both CRL and AMA brand windows. The AMA rear door window seems to look exactly like the OEM or CRL window, but $50 less per window. Anybody have experience with AMA brand windows?

AMA brand rear door window: https://www.vanwindowsdirect.com/collections/ram-promaster-van-windows/products/ama-rear-cargo-door-windows-ram-promaster-van-window-passenger-side

CRL brand rear door window: https://www.vanwindowsdirect.com/collections/ram-promaster-van-windows/products/crl-oem-design-all-glass-look-2014-2017-ram-promaster-van-fixed-window-left-rear-door-all-models-fw384l
 

Registered
Joined
1,340 Posts
I'm also interested in the AMA slider glass at $170.
Just curious as to why it is significantly cheaper.
It mentions trim edge molding with 1/8" opening. That's much too big for the sheet metal edge, so I'm wondering if that's for the glass.
1/8" glass would explain the price.
But I don't want 1/8" glass.
They don't offer any descriptions or pics of anything.
 

Registered
Joined
2,726 Posts
Discussion Starter #5
trim edge molding
That should be for the ragged metal edge from cutting the hole, I think it's U shaped molding.
 

Registered
Joined
1,340 Posts
I think you are correct.
And now that I think about it, it would fit over 2 layers of sheet metal, not one., So the 1/8" opening wouldn't be that sloppy. Plus it appears to have a rubber barb inside so it would be snug.
I'm liking the AMA for that price.
 
1 - 6 of 6 Posts
Top