Ram Promaster Forum banner

Transmission pan torque setting and bolt pattern

756 Views 5 Replies 5 Participants Last post by  MsNomer
Hello. I was wondering if anyone knew the torque setting needed for the transmission pan bolts and also the bolt fastening pattern?

Thanks!
1 - 2 of 2 Posts

· Registered
Joined
·
8 Posts
Discussion Starter · #4 ·
I did the 105 inch pounds as el jefe suggested with a crisscross type pattern. I replaced the trans pan tonight with the dorman one with a drain plug and the felpro gasket. Everything seems to be good so far as far as leaks go.

The van is a 2018 1500 136 wb high roof with 32k miles on it. I got it towards the end of september and put about 2k miles on it. When shifting into first it is not as smooth as I would like and thought a fluid and filter change would help. It did a little. At this point I am going to keep on driving it and monitor it to see if it gets worse.
 
1 - 2 of 2 Posts
Top