Ram Promaster Forum banner
1 - 5 of 5 Posts

Registered
Joined
29 Posts
Discussion Starter · #1 ·
Hi,

We have a VWD window in our slider door and, as has previously been noted, the screen is on the outside. The adhesive which holds the velcro to the van (which holds the screen on) failed, likely due to the fact that it reaches triple digits here occasionally and that side of the van faces due south.

Last summer (after the screen fell out) I used standard gorilla glue to put it back on (the remnants of which you can see in the window still). This 'fix' failed again this summer.

Any recommendations for a different adhesive to use? I'm not exactly sure what type of plastic the screen is made of; it's glossy black and hard. The hard part is that it gets sun constantly in the summer along with triple digit temps on occasion.

Thanks in advance! And wow! those windows look dirty. Looks cleaner in real life..馃槵

Plant Building Window Shade Motor vehicle




Rectangle Mesh Grille Automotive exterior Grass


Leaf Plant Fines herbes Road surface Grass
 

Attachments

Registered
Joined
29 Posts
Discussion Starter · #3 ·
Sounds good, thank you for the suggestion! VWD is kindly sending another screen (with the velcro they use to attach it), but I will try this first. Thanks!
 

Registered
Joined
29 Posts
Discussion Starter · #5 ·
I am not sure if this was not the same adhesive (it is 'velcro', maybe not official 'Velcro'), or if actually gets close to 150' in the sun. There is also a fair amount of size variation as the screen surround heats up, and as the screen surround expands it gets a touch bigger than the window area designed to hold it, and then sort of buckles out of the window. I was planning on shaving down the surround on this second window before installation to see if that helped decrease strain on the adhesive.

All that being said, I think the original design of using velcro to hold an exterior screen onto a van which can go 90MPH for hours at a time is not optimal.
 

Registered
Joined
29 Posts
Discussion Starter · #7 ·
I was going to glue the old frame to the window and permanently (until it falls out again 馃槀) put the screen in place. I think I was unclear about that in my last post. The new screen with velcro would be a backup for when the old screen and SEM seam sealer fail at speed (instead of the driveway) and are unrecoverable.
 
1 - 5 of 5 Posts
Top