Ram Promaster Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
102 Posts
Discussion Starter · #1 ·
Guys, I need some help?
I am looking for interior panels for the cargo area for a 136" low boy.
What I actually would like is a set of Patterns (Traces) of the OEM side panels, with all the fastener holes, marked.
I have the rear doors and the passenger slider panels.
Shipping to Canada would be expensive.
They are not available from the dealer.
I would like to fab them out of 1/4" plywood and then cover.
I am willing to pay you for your time and the cost of postage, as you could roll them up and put them in a tube.
The reason for OEM panels, I want to secure them with factory fasteners, for easy access.
Thanks guys.
Love my van!
 

·
Registered
Joined
·
1,162 Posts
Welcome to the club Wally. That is...welcome to the club of guys who would love to buy panels and pop them in, but nobody makes such a thing.

So far as i know, were in the same boat. Cut a cardboard template, transfer it to wood, screw it directly to the sheet metal.
 

·
Registered
Joined
·
102 Posts
Discussion Starter · #3 ·
Panels

Thanks Kip,
it was worth a try.
I can make some panels, but I am trying to stay away from screws.
Why make life, more difficult than it already is!
Mike from Banff
 

·
Registered
Joined
·
1,162 Posts
I am still procrastinating about doing the interior on my two vans, but I have a hunch that when I finally do I'll just commit to double sided tape. It'll be a pain if I ever want to run wiring or otherwise get behind them, but tape is a viable option. Velcro is another.
 
1 - 4 of 4 Posts
Top