Ram Promaster Forum banner

1 - 6 of 6 Posts

·
Registered
2014-159 HR in CT
Joined
·
3,508 Posts
Discussion Starter #1
... that's directly behind the driver and passenger door.

I removed the black boots, and it seems like there is more than clips holding the column cover on... any thoughts or experience?

I want to add a grab bar for the slider door and need to route a few wires up from the Upfit connector.

Thanks in advance!:)
Ed
 

·
Super Moderator
Joined
·
10,135 Posts
There is a screw on the bottom after you remove the black piece then give the BEIGE piece a good yank on the bottom. There is a plastic clip at the bottom middle if the beige piece.

But, Ed already figured this out!
 

·
Registered
Joined
·
88 Posts
I've been running wires through the column. I'm wondering if there is any concern with the wires interfering with the airbag? I didn't take the column trim off, I dropped the wires down from the top to the upfitter connector
 

·
Registered
2014-159 HR in CT
Joined
·
3,508 Posts
Discussion Starter #6
There is a screw on the bottom after you remove the black piece then give the BEIGE piece a good yank on the bottom. There is a plastic clip at the bottom middle if the beige piece.

But, Ed already figured this out!

Yes, I found the screw, and loosened the panel enough to get my grab handle installed.

Thanks to all!

Ed

ps....Looks grey to me, especially next to my granite body paint
 
1 - 6 of 6 Posts
Top