Ram Promaster Forum banner

41 - 42 of 42 Posts

·
Registered
Joined
·
33 Posts
I feel your pain.I tried a few methods on this site with no results. This method does work. Refer to the pic in post #1.

My final setup was 2.5 ohms on the airbag connection, 460 ohms (in place of the 2300 in the pic) on the seat belt connection and 400 ohms for the occupancy sensor. Just cycling the ignition didn't clear the SRS light for me. After starting the van and running for a minute or so, the lights cleared.
 

·
Registered
Joined
·
8 Posts
These are not actual OEM seats, they are seats purchased from discountvantruck. Ordered 2.5 ohm resistors
2.4 ohm resistors in the orange clip under both the passenger and driver seats, cleared the message. As stated by others. you have to cycle the engine 2 or 3 times after installing the resistors to clear the messages.

I have quantity 90 2.4 ohm and quantity 90 390 ohm resistors if anybody wants a few. PM me your address.
 
41 - 42 of 42 Posts
Top