Ram Promaster Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-9 of 9 Results
  1. Appearance and Body
    new item posted on another forum, Bike-Hook RAM Promaster Series - Any Height - 2014 to Current Year ONE - TWO - THREE - Bike-Hook
  2. Promaster General Discussion Forum
    I had a hitch rack but it bent and cracked in less than a year. I used the basket from it and bolted it through the door, then hung it with chains. The bolts are all backed with angle iron and washers to distribute the force across the entire door. Now I can easily open both back doors!
  3. CB_mount_close.jpg

    Close up view of the Breedlove CB antenna mount. The ball is "hot" and isolated from the mount by a Delrin bushing.
  4. CB_mount_far.jpg

    View of the Breedlove antenna mount for the CB antenna, showing position on the van.
  5. HF_mount_Close.jpg

    Close up view of the Breedlove mount for the HF Screwdriver (not shown). The wire is the control line for the screwdriver motor. The ball is "hot" and isolated from the mount by a Delrin bushing
  6. HF_mount_far.jpg

    View of the Breedlove mount for the HF screwdriver (not shown), showing the location on the left side of the van.
  7. VHF_mount_close.jpg

    Close up view of the Breedlove VHF/UHF antenna mount. the mount itself is a SO-239 connector, with the cable running through the mount into the van.
  8. VHF_mount_far.jpg

    View of the Breedlove antenna mount for the VHF/UHF antenna, showing location on the left side of the van.
  9. Promaster General Discussion Forum
    2014 136" Promaster gas- flexplate failure at 31K miles. Broken trans mount might have been causing the issue. 3 months past 5-year power train warranty and the dealer/ morpart would not cover it. 5-7 hour job plus parts. Cost me $1500 after tax at the dealer with trans mount replaced. But I was...
1-9 of 9 Results
Top