Join Date: Dec 2016
Thanked 7 Times in 6 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 3 Post(s)
So far this weekend . . . .got the Curt trailer module mostly in. (easy), Pulled 110v extension cords from box at drivers B pillar to pass B,C,D pillar locations . Got the pass side front "spot"in , but broke another plastic moulding retainer doing it! 2 forward, 3 back . LEDs under slider in . Pulled all (?) wires along roof channels and down to endings and labeled. And pulled "trailer ribbon" all over too (in case I missed/upgrade).
There's enough room behind the rear "vents" to put the fuses,relays, etc, for next session.
Tomorrow when the cats 'n dogs are coming down I will make the timer/relay assemblies, maybe make a panel to hold the fuses ,blocks, etc.
I draw out the schematic cartoons and when I put all of them together it looks like a plate of spaghetti . Made the picture look much better when the wires were strung ad the ends were labeled.